Brother ADS2600W код ошибки
02.12.2019 10 0.0 0
  • Code: 0B00 ... 0D00
  • Display:
  • Description:These errors do not usually occur during normal use. The possible causes are noise around the installation site, fluctuation of the power supply voltage, and failures in the software. An unidentified error occurred.
  • Remedy:1 Main PCB failure Replace the main PCB ASSY.
  • Code: 0E00
  • Display:
  • Description:Communication between the panel PCB and the main PCB cannot be established at machine startup.
  • Remedy:1 Connection failure of the panel PCB harness Reconnect the panel PCB harness. 2 Panel PCB failure Replace the panel PCB ASSY. 3 Main PCB failure Replace the main PCB ASSY.
  • Code: 0F00 ... 3A00
  • Display:
  • Description:These errors do not usually occur during normal use. The possible causes are noise around the installation site, fluctuation of the power supply voltage, and failures in the software. An unidentified error occurred.
  • Remedy:1 Main PCB failure Replace the main PCB ASSY.
  • Code: 3B00
  • Display:Unable to Scan 3B See Troubleshooting in User's Guide.
  • Description:An error occurred during access to the DRAM in the main PCB.
  • Remedy:1 Main PCB failure Replace the main PCB ASSY.
  • Code: 3C00 ... A100

  • Display:
  • Description:These errors do not usually occur during normal use. The possible causes are noise around the installation site, fluctuation of the power supply voltage, and failures in the software. An unidentified error occurred.
  • Remedy:1 Main PCB failure Replace the main PCB ASSY.
  • Code: A200
  • Display:Document Jam/too Long See Troubleeshooting in Use's Guide.
  • Description:The document scanning position sensor detected that the document length was 40 cm or more while scanning a document.
  • Remedy:<User Check> • Set the document length within the standard.
    1 Document scanning position actuator caught in sections of the machine Reattach the document scanning position actuator. 2 Document scanning position sensor failure Replace the document scanning position sensor PCB ASSY. 3 Main PCB failure Replace the main PCB ASSY.
  • Code: A300
  • Display:Document Jam/too Long See Troubleeshooting in Use's Guide.
  • Description:The document scanning position sensor has not detected the top of the document even after the document has been fed for the specified distance.
  • Remedy:<User Check> • Set the document in the ADF correctly.
    1 Document scanning position actuator coming off Reattach the document scanning position actuator. 2 Document scanning position sensor failure Replace the document scanning position sensor PCB ASSY. 3 Main PCB failure Replace the main PCB ASSY.
  • Code: A400
  • Display:Cover is Open Close the front cover.
  • Description:The front cover sensor detected an open front cover.
  • Remedy:<User Check> • Close the front cover correctly.
    1 Connection failure of the front cover sensor harness Reconnect the front cover sensor harness. 2 Tab to push the front cover sensor is broken Replace the front cover. 3 Front cover sensor failure Replace the front cover sensor. 4 Main PCB failure Replace the main PCB ASSY.

Теги:Brother ADS2600W error code, Brother ADS2600W код ошибки

Читайте также:
Комментарии
comments powered by HyperComments